Proline Pipe Equipment

PSI® Thunderline Link-Seal

PSI® Casing Spacers PSI® End Seals Century Sleeves

Casing Spacers and End Seals

PSI Thunderline Link-Seal PSI® Thunderline Link-Seal

A modular permanent seal for any pipe through walls, floors and casing
Installation takes less than 5 minutes
Expands around the space to create a gas and watertight seal
Rated at 20 psi (40 ft. of head)
Resists aging, ozone, sunlight, water, a wide range of chemicals, extreme high 400ºF (204.44ºC) and low -60ºF (-51ºC) temperatures
Eliminates metal to metal contact preventing galvanic corrosion
Reduces pipe failures due to fatigue at welds, flanges and threaded connections

PSI Casing Spacers PSI® Casing Spacers

Designed specifically for oil and gas, water and sewer cased pipelines
Provides long-term corrosion protection
Comes in heavy duty painted steel, stainless steel or economical polyethylene
Available in fusion coated steel for the ultimate in strength, toughness and extended life
Stud mounted and/or projection welded glass reinforced plastic runners molded under high pressure
Deeply embossed flanges for added strength during tightening of flange bolt

PSI® End Seals

Creates a tight seal or barrier on the ends of the pipe
Individually designed to accommodate all types of water and sewer pipes and carrier/casing combinations.
Made of ⅛" (.3175 mm) thick synthetic rubber for long life and easy installation
Available in custom pull-on, wrap around or standard pull-on models

Century Sleeves

Century-Line® Sleeves Model CS

Century-Line® Sleeves Model CS are used to create circular sleeved holes in concrete poured barriers including; walls, floors, ceilings, structural supports and tank footings. Molded
from non-conductive, high impact resistant HDPE, Century-Line® sleeves are lightweight and easily installed by one construction worker.

WS Wall Sleeves

WS Wall Sleeves are constructed from steel and available in a wide range of diameters and lengths. They are an excellent choice for installations where the Link-Seal® Modular Seal and WS sleeve assembly would be subject to extremely high temperatures or where fire seals are specified.